A sheet of labels is expensive to waste. Print this page on plain paper first, measure it with a ruler, and you know whether your printer prints at the real size and where it puts the page. It is not tied to any label code.
How to print it
- Open the PDF and print it on plain paper, not on labels.
- Set the scale to Actual size or 100%. Turn off Fit to page, Fit to paper and Fit to printable area.
- Set the paper size (US Letter or A4) in the print dialog and in the printer's own settings.
What to measure
| What | A correct print measures |
|---|---|
| The bar along the top | 180 mm |
| The bar down the left | 200 mm |
| The ruler along the bottom | 7 inches |
| The centre of each cross, from the two paper edges next to it | 12.7 mm (1/2 inch) |
What the result means
- A bar is clearly shorter or longer than it should be: the page was resized. Check the scale and the paper size, then print the page again. An offset cannot fix a resized page.
- A bar is off by 1 mm or less with the settings right: your printer may stretch the page a little. See the stretch correction in the guide on misaligned labels.
- The bars are right, but the crosses are all the same distance too far in one direction: your printer shifts the page. Measure from the left edge and from the top edge to the top left cross. On A4 the offset is 12.7 minus the left distance for X and 12.7 minus the top distance for Y, all in millimetres. On US Letter work in inches: 0.5 minus the left distance for X and 0.5 minus the top distance for Y. Plus moves the print right or down, minus moves it left or up. Type the two numbers as they are in the add-on: its box is in millimetres on A4 and in inches on US Letter.
- Crosses are missing, or not 12.7 mm from their edge on one side only: check the paper size first. It must match the paper in the tray, in the print dialog and in the printer settings. If the paper size is right, your printer cannot print that close to the paper edge, and you can still measure a bar that prints in full, or the distance between ruler marks you can see.
In Peelstack Label Maker, open "Labels print a little off? Align your printer" and enter the two numbers. The add-on remembers them for that paper size.
Next
- Print the test page for your own label sheet from its page in the list of supported label sheets.
- Labels still drift down the page? Read how to fix misaligned labels.
- Not sure which sheet you have? Try Find your label sheet.
Avery® is a trademark of Avery Products Corporation or its affiliates. Taskivator is not affiliated with Avery.